JVC CA-EX90 Bedienungsanleitung PDF herunterladen (Seite 19)

19 CA-EX90

Setting the Clock

This unit incorporates a clock with a 12-hour display. Be sure to set the clock before operating the

unit. The clock can be set either in ON or STANDBY mode of power.

Use the remote control unit to set the clock.

1 Press CLOCK/TIMER.

2 Set the time of the day.

1 Set the hour.

Use +/R or –/L to display the appropriate hour, then

press SET.

Hold down +/R or –/L to change the hour sequentially.

2 Set the minutes.

Use +/R or –/L to display the appropriate minute, then

press SET.

Hold down +/R or –/L to change the minutes in 10

minutes steps.

• If you set the clock while the power is on, the display

returns to the previous information after completing the

clock setting.

To set the clock precisely

After setting the minutes, press SET in sequence with the time announcement on the TV, radio or

telephone service. This starts the clock counting from 0 seconds of the set minute.

Why set the time?

Setting the time allows you to use the daily and recording timer operations.

The daily and recording timer operations cannot be set unless the clock has been set. To correct the

previously set time, press CLOCK/TIMER repeatedly (5 times) so that the hour blinks to enter the

clock set mode.

Notes

• Pressing buttons other than those described above while setting the clock will cancel the clock

setup. If this occurs, resume setting the clock from step 1.

• In case of a power failure (or when the power cord has been unplugged) the clock may show the

time of the power failure, or a blinking “AM 0:00”. If this occurs, reset the clock to the correct

time.

Blinks.

After setting the hour

(before pressing SET)

CLOCK

/ TIMER

–

SET

EN01-23.CA-EX90[J]/5/18 98.6.8, 8:20 AM19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 53 54

Keine Kommentare

JVC CA-EX90 Bedienungsanleitung Seite 19